Category Archives: Capacitor charger

Making Your Batteries Last.

I may have mentioned this previously as part of another post, but I am going to cover just the rechargable batteries in this post. Namely how to make them last as long as they were designed for. Why is this … Continue reading

Posted in Batteries, Battery charger, Capacitive charger, Capacitor charger, charger, Primary Cells, Recycling, Uncategorized | Tagged , ,

Just Some Idle Notes

Other chargers have been attempted for charging “Primary” Alkaline cells, but they too suffered various limitations, from undercharging the cell so it had minimal capacity, or they suffered from the same failures from heat of the “Alkaline Charger”- Namely leakage and small explosions. This is usually the result of a lack of diffusion and localized heating within the cells. The cycling will hopefully address this issue so effective charging will occur. Continue reading

Posted in Alkaline Charging, Alternative Energy, Battery charger, Bedini, Capacitive charger, Capacitor charger, charger, Homebrew, Incandescent light bulbs, lead acid batteries, Project, Renassaince, Reverse Current charger | Tagged , , , , ,

Another Pulse Charger

…This is a lot more sophisticated than previous circuits, but this one can be adjusted for current flow through the cells by using a higher value zener and adjusting the value of R1 to protect Zener. As shown it is suitable for a 6 volt lead acid or Nickel Cadmium or Nickel Metal Hydride battery array of 6 volts (5 cells) or 4 alkaline cells experimentally. … Continue reading

Posted in Alkaline Charging, Battery charger, bread boardiing, breadborads, Capacitive charger, Capacitor charger, charger, Project, Reverse Current charger, Uncategorized | Tagged , , , , , , , , , , , ,

Atmospheric Power Tap: Fact or fiction? We shall see.

I came across it while looking for information that led to the capacitive charger circuit I blogged about earlier this year. Some called this next arrangement a “Capacitive Charger” but it really isn’t that at all. In the realm of “free energy,” this one is about as close to realistic as most of those concepts get. Continue reading

Posted in Battery charger, Bedini, Capacitive charger, Capacitor charger, charger, Free Energy, Homebrew, lead acid batteries, Over Unity, Project, Renassaince, Uncategorized | Tagged , , , , , , , , ,

More on the Capacitive Charger

Mind you- the Capacitive charger is a slightly different beast, but you can use the Application Note as a reference to refine the charger and normalize the concept of the capacitive charger. The importance being the calculations. The real notable difference is as a battery charging circuit, the battery is both a load and a capacitance in the circuit, so there is no need for the 470 microfarad capacitor or the zener diode that are shown in the Application Note. The equations provided will also allow for a bit of optimization and also allow those on 50 Hertz/250 volt standards to modify the charger a bit closer to optimal for their area of the world. Continue reading

Posted in Alkaline Charging, Battery charger, Capacitive charger, Capacitor charger, Charge Controllers, charger, Project, references, Reverse Current charger, Uncategorized | Tagged , , , , , , , , , | 2 Comments

A Partial Update on Capacitive Charger

I added some capacitance to the charger, so now there is 10 microfarads total capacitance. I just added them parallel to the original. Rain has prevented using the charger for over a week. Until the charger is fully tested, the … Continue reading

Posted in Battery charger, Capacitive charger, Capacitor charger, Charge Controllers, charger, desulphator circuit, lead acid batteries, Project, Uncategorized | Tagged , , , , , ,

Capacitor, Capacitive Battery Charger Circuit.

My preliminary battery chosen was a motorcycle battery that had been sitting outside over winter, and was likely 4 to 7 years old and therefore an excellent candidate for sulphated plates. The charger itself is nothing more than an industrial bridge rectifier I could only infer was a 9 Amp 900 volt PIV as I could not locate a datasheet. The capacitor was a 250 VAC, 3 microfarad capacitor- non-polarized. That was it. Not counting cord or wires. The capacitor was wired to the line side of the mains power, in the event of a failure, it was the shortest potentially exposed path for AC current in the event of failure. Continue reading

Posted in Battery charger, Bedini, Capacitive charger, Capacitor charger, charger, desulphator circuit, Free Energy, Homebrew, Incandescent light bulbs, lead acid batteries, Over Unity, Project, Renassaince, Reverse Current charger, Uncategorized | Tagged , , , , , , , , , , , , , , , | 1 Comment