Tag Archives: Charge Controllers. Ciruits

More on the Capacitive Charger

Mind you- the Capacitive charger is a slightly different beast, but you can use the Application Note as a reference to refine the charger and normalize the concept of the capacitive charger. The importance being the calculations. The real notable difference is as a battery charging circuit, the battery is both a load and a capacitance in the circuit, so there is no need for the 470 microfarad capacitor or the zener diode that are shown in the Application Note. The equations provided will also allow for a bit of optimization and also allow those on 50 Hertz/250 volt standards to modify the charger a bit closer to optimal for their area of the world. Continue reading

Advertisements
Posted in Alkaline Charging, Battery charger, Capacitive charger, Capacitor charger, Charge Controllers, charger, Project, references, Reverse Current charger, Uncategorized | Tagged , , , , , , , , , | 2 Comments

Some useful references I have found over the years and some useful notes

…but perhaps most important are the Data sheets, Application Notes and “Suggested designs” from the manufacturers themselves. Sometimes sample circuits are presented in the Data sheets, otherwise look to Application Notes. Some of the Application notes are even compiled into a book in such a way that the book could be used as a textbook… Continue reading

Posted in bread boardiing, breadborads, dead bug, flashing, flashing a generator, generator, Homebrew, how to fix generator that eill not charge, Prestolite, Project, Reference books, references, Uncategorized | Tagged , , , , , , , , , , , , ,

Capacitor, Capacitive Battery Charger Circuit.

My preliminary battery chosen was a motorcycle battery that had been sitting outside over winter, and was likely 4 to 7 years old and therefore an excellent candidate for sulphated plates. The charger itself is nothing more than an industrial bridge rectifier I could only infer was a 9 Amp 900 volt PIV as I could not locate a datasheet. The capacitor was a 250 VAC, 3 microfarad capacitor- non-polarized. That was it. Not counting cord or wires. The capacitor was wired to the line side of the mains power, in the event of a failure, it was the shortest potentially exposed path for AC current in the event of failure. Continue reading

Posted in Battery charger, Bedini, Capacitive charger, Capacitor charger, charger, desulphator circuit, Free Energy, Homebrew, Incandescent light bulbs, lead acid batteries, Over Unity, Project, Renassaince, Reverse Current charger, Uncategorized | Tagged , , , , , , , , , , , , , , , | 1 Comment

Miscellaneous MOSFET notes.

I mentioned early on in this blog that other MOSFETs could work, and they will work in most cases as long as they are in circuits that are within their peak ratings. Continue reading

Posted in Charge Controllers, Homebrew, Project, Solar Panel, Solar power, Uncategorized | Tagged , , , , , , , , , , , , , , , , , , , , , ,

I will post a link to a charger that some will deny could work.

The principle is simply collecting accumulated static charge off dust, snow and rain that strike the antenna, The spark plug fires when potential reaches a certain point, and that collapsing magnetic field of the high tension side induces a current in the low voltage side Continue reading

Posted in charger, Free Energy, Homebrew, Magnetic impulse charging, Project, Uncategorized | Tagged , , , , , , , , ,

These battery chargers are not for fools and idiots

While charging alkalines, check the temps periodically. Those that may be prone to failure will be notably warmer than the other cells. If one is encountered, unplug charger and test the voltage of that particular cell- it may be fully charged, but in any event it should be taken out of the charger and another discharged cell slipped in. Continue reading

Posted in Alkaline Charging, Bedini, Charge Controllers, charger, Free Energy, Homebrew, Incandescent light bulbs, Magnetic impulse charging, Monopole Motor, Over Unity, Project, Renassaince, Reverse Current charger, Uncategorized | Tagged , , , , , , , , , , , , , , ,

An adjustment for the Alkaline Charger.

Changing this single bulb charger to a 7 1/2 Watt incandescent light bulb reduces the charging rate and therefore allows for the gasses that sometimes build up to escape. There will still likely be some failures encountered at this charging rate, but they should be much lower in incidence than occurs with a 25 Watt bulb or 40 Watt bulb. Any charger will have failed cells, it is part of the chemistry of primary cells. Continue reading

Posted in Alkaline Charging, Bedini, Charge Controllers, charger, Free Energy, Homebrew, Incandescent light bulbs, Magnetic impulse charging, Monopole Motor, Over Unity, Passive heat, Project, Renassaince, Reverse Current charger, Solar Panel, Solar power, Uncategorized | Tagged , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , , ,