Tag Archives: pulse charging

Just Some Idle Notes

Other chargers have been attempted for charging “Primary” Alkaline cells, but they too suffered various limitations, from undercharging the cell so it had minimal capacity, or they suffered from the same failures from heat of the “Alkaline Charger”- Namely leakage and small explosions. This is usually the result of a lack of diffusion and localized heating within the cells. The cycling will hopefully address this issue so effective charging will occur. Continue reading

Advertisements
Posted in Alkaline Charging, Alternative Energy, Battery charger, Bedini, Capacitive charger, Capacitor charger, charger, Homebrew, Incandescent light bulbs, lead acid batteries, Project, Renassaince, Reverse Current charger | Tagged , , , , ,

Another Pulse Charger

…This is a lot more sophisticated than previous circuits, but this one can be adjusted for current flow through the cells by using a higher value zener and adjusting the value of R1 to protect Zener. As shown it is suitable for a 6 volt lead acid or Nickel Cadmium or Nickel Metal Hydride battery array of 6 volts (5 cells) or 4 alkaline cells experimentally. … Continue reading

Posted in Alkaline Charging, Battery charger, bread boardiing, breadborads, Capacitive charger, Capacitor charger, charger, Project, Reverse Current charger, Uncategorized | Tagged , , , , , , , , , , , ,

Atmospheric Power Tap: Fact or fiction? We shall see.

I came across it while looking for information that led to the capacitive charger circuit I blogged about earlier this year. Some called this next arrangement a “Capacitive Charger” but it really isn’t that at all. In the realm of “free energy,” this one is about as close to realistic as most of those concepts get. Continue reading

Posted in Battery charger, Bedini, Capacitive charger, Capacitor charger, charger, Free Energy, Homebrew, lead acid batteries, Over Unity, Project, Renassaince, Uncategorized | Tagged , , , , , , , , ,

A Partial Update on Capacitive Charger

I added some capacitance to the charger, so now there is 10 microfarads total capacitance. I just added them parallel to the original. Rain has prevented using the charger for over a week. Until the charger is fully tested, the … Continue reading

Posted in Battery charger, Capacitive charger, Capacitor charger, Charge Controllers, charger, desulphator circuit, lead acid batteries, Project, Uncategorized | Tagged , , , , , ,

Capacitor, Capacitive Battery Charger Circuit.

My preliminary battery chosen was a motorcycle battery that had been sitting outside over winter, and was likely 4 to 7 years old and therefore an excellent candidate for sulphated plates. The charger itself is nothing more than an industrial bridge rectifier I could only infer was a 9 Amp 900 volt PIV as I could not locate a datasheet. The capacitor was a 250 VAC, 3 microfarad capacitor- non-polarized. That was it. Not counting cord or wires. The capacitor was wired to the line side of the mains power, in the event of a failure, it was the shortest potentially exposed path for AC current in the event of failure. Continue reading

Posted in Battery charger, Bedini, Capacitive charger, Capacitor charger, charger, desulphator circuit, Free Energy, Homebrew, Incandescent light bulbs, lead acid batteries, Over Unity, Project, Renassaince, Reverse Current charger, Uncategorized | Tagged , , , , , , , , , , , , , , , | 1 Comment

I will post a link to a charger that some will deny could work.

The principle is simply collecting accumulated static charge off dust, snow and rain that strike the antenna, The spark plug fires when potential reaches a certain point, and that collapsing magnetic field of the high tension side induces a current in the low voltage side Continue reading

Posted in charger, Free Energy, Homebrew, Magnetic impulse charging, Project, Uncategorized | Tagged , , , , , , , , ,

These battery chargers are not for fools and idiots

While charging alkalines, check the temps periodically. Those that may be prone to failure will be notably warmer than the other cells. If one is encountered, unplug charger and test the voltage of that particular cell- it may be fully charged, but in any event it should be taken out of the charger and another discharged cell slipped in. Continue reading

Posted in Alkaline Charging, Bedini, Charge Controllers, charger, Free Energy, Homebrew, Incandescent light bulbs, Magnetic impulse charging, Monopole Motor, Over Unity, Project, Renassaince, Reverse Current charger, Uncategorized | Tagged , , , , , , , , , , , , , , ,